temperature

The reliable function of hydraulic and lubrication systems depend to a high extend on a stable operating temperature of the oil. Therefore it is essential that the actual temperature is timely and accurately measured. Normally it is done inside of the tank due to a representative average to be expected. The cover of the tank is the preferred spot for the installation of the sensors penetrating down into the liquid. The sole measurement of temperature is recommended only if combined sensors with the level controls are not applicable.

Temperature sensors Thermotronik TT-77

electronic temperature switch
up to 4 programmable set points
alternative continuous temperature signal plus 1 programmable set point
window and hysteresis function
two outputs programmable 1-100 Hz
max/min. memory
direct or remote installation
LED display with status indication 270° rotatable
standardized manu structure
dip tube length up to 1 meter

Datasheet (323 kb)Instruction manual (2,658 kb)

Temperature sensors

TF-M/E-G1/2

Pt 100 RTD
continuous signals
dip tube up to 1 meter
dip tube brass or stainless stell optional
various connector options

MK2-G1/2/ EK2-G1/2

cost effective temperature sensor with integrated transmitter
continuous 4-20mA output
dip tube up to 1 meter
dip tube brass or stainless stell optional
various connector options

TF-M-VAL

Pt100 RTD spring loaded
continuous signals
various connector options

Datasheet (243 kb)Instruction manual (218 kb)

Bi-metal Temperature switches

TSM-G1/2, TSE-G1/2

G1/2" male thread
up to 2 switch points
dip tube up to 1 meter
various connector options

TSK-G3/4

G3/4" male thread
up to 2 switch points
dip tube up to 1 meter
low hysteresis
various connector options

T_A

G1/2" male thread
1 temperature set point
fix length 29 mm
various connector options

Datasheet (186 kb)Instruction manual (218 kb)